Xplorer Mark 3 Servo Install

In my previous post about my new Xplorer Mark 3 I detailed how I setup the wing for pushrod exits. Now that I have each of the exits cut, the linkages measured, and the servo frame locations set it is time to glue those frames onto the inner skin of the wing. Let’s talk about a Xplorer Mark 3 servo install! Each step in this build, especially when it comes to the wing has been one where once undertaken cannot be undone. It really isn’t more evident than gluing in those servo frames. Once cured those frames are impossible to … Continue reading

Xplorer MK3 Build

I recently purchased a NAN Xplorer Mark3. After looking and marveling at the craftsmanship I knew it was time to put it together. I’m very lucky to live in an area with some amazing sailplane pilots. Jody Miller, Jeff Duval, and Dillon Graves are all local pilots that have a great track record for building great flying models. Jeff and Dillon are current USA F3J Team pilots and Jody was on the 2014 team. I’ll be enlisting each of them for help building my model. Starting Xplorer MK3 Build The first thing I decided to do was to cut the pushrod exits for the flaps. Even … Continue reading

Purchasing an Xplorer Mark 3

Mike and His Xplorer

I finally did it! Six months of saving and a bonus from work allowed me to pull the trigger on an Xplorer Mark 3! This model is out of this world in terms of quality. Everything seams are sealed. There is no molding marks. The tail group! Oh, the tail group! When I picked up the rudder I thought there was something wrong. It was so light! For a 4 meter (154 inches) glider I am amazed at how light it feels. The size really makes this impressive. Here are the weights: Center Panel 591g Right Tip 234g Left Tip 225g … Continue reading